Why is my Hunter sprinkler controller repeating itself?
Why is my Hunter sprinkler controller repeating itself?
The controller repeats itself or continuously waters, even when it should not be on (cycling repeatedly). Too many start times (user error). Only one start time per active program is required. The Start Time numbers do not represent station numbers. There is no display. Check AC power wiring.
Why do my sprinklers continue to cycle over and over?
A common irrigation problem is sprinklers continuing to cycle over and over. The answer often lies in an improperly programmed controller. In this article, we will look at basic programming. Here are the basic controller programming steps.
Why does my sprinkler controller not show the start time?
The controller does not have a start time for each station. Programming error, dial in incorrect position. Be sure the dial is in correct position. Total number of stations can be easily checked by placing dial in the RUN TIMES position and pressing the back arrow.
How can I Stop my sprinkler system from running?
Your controller will have this feature labelled “run”, “auto”, or “auto run”, depending on the model and brand. The setting enables your scheduled programs to run as planned. If you want to prevent your programs from running, switch your controller to the “off” or “stop” position. Your program settings will be saved.
Why does my sprinkler system keep running even when the controller is off?
Even when the controller turns off, it still runs indefinitely. The problem is most likely located in one of the solenoid valves. These valves are usually located in an underground access box outside in the yard. Before you call your irrigation service provider, you might want to take a look inside the access box.
What makes a hunter sprinkler system so good?
Homeowners Hunter is committed to manufacturing top quality products that use only the water and energy needed to get the job done efficiently. Golf Hunter takes pride in making sure our Golf experts and professionals receive the support they need to conceptualize, execute, and complete their job.
Why does my irrigation system repeat a cycle?
A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time. Individual stations are assigned to a program (A,B,C).
What does run time mean on a sprinkler system?
Run time, sometimes called “station duration”, is the time in minutes a valve remains open and waters each zone (e.g. zone 1 = 10 minutes, zone 2 = 10 minutes, etc., until your chosen zones in program A have run their set times). Your controller will have this feature labelled “run”, “auto”, or “auto run”, depending on the model and brand.
