Why does my sprinkler turn on twice?

Why does my sprinkler turn on twice?

A common reason why a program is repeating is that you have a second start time set. The start times control the exact time your ESP-Me timer will begin to water and they also control how many times a day your timer will water. The ESP-Me allows you to set up to 6 start times per program.

How do you reset an old hunter pro c controller?

Pro-C (older models)(with Manual All Station dial position)

1. Turn the dial to the RUN position.
2. Remove the 9V battery.
3. Hold down the , and program buttons simultaneously.
4. While holding down the three buttons, press and release the Reset button on the back of the front panel.
5. Release all three buttons.

What’s the start time for the Hunter Pro C controller?

If you set zone 1 for 10 minutes and zone 2 for 10 minutes, and set start time 1 for 10am and start time 2 for 6am, both zones will run consecutively at both of those times. What is the model of your controller? I’m not an expert by any means, but make sure the program B start time (s) aren’t overlapping the run time of program A.

Is there delay between stations on Hunter irrigation controller?

Users can program a delay between stations as the controller advances from one station to the next. This delay can range from a few seconds (to permit slow-closing valves additional time to close) to a much longer period of time (to allow pressure tanks time to recharge), based on user requirements.

What does the Hunter Pro-HC WiFi irrigation controller do?

The Pro-HC controller has a full graphical touchscreen interface, which makes programming with or without Wi-Fi connectivity and manual starting from the controller a breeze. Daily schedule adjustments, based on local weather data, monitor past, current and forecasted temperature, rainfall, humidity, and wind speed.

Why are the zones not the same on Hunter Pro-C?

If you’re trying to set two different times for two different valves in A, that’s your problem there. The start time numbers are not zone numbers. If you set zone 1 for 10 minutes and zone 2 for 10 minutes, and set start time 1 for 10am and start time 2 for 6am, both zones will run consecutively at both of those times.

Can a Hunter Pro-C controller have multiple programs?

Hunter controllers have multiple programs (A, B, and C) and the ability for each program to have multiple start times. To set up each program, you would need START TIMES, RUN TIMES, and WATER DAYS for each of them. Here is an example of a program for a 4 station controller: You have a 4 Station Pro-C controller.

How to change run times on Hunter Industries Pro-C?

1 Turn the dial to the START TIMES position. Look for the capital “A” near the start time number. 2 Turn the dial to RUN TIMES. Press the “+” or “-“ button to change station 1 to 6-minute run time (0:06). 3 Turn the dial to the WATER DAYS position. The symbol above “MO” should be flashing.

If you’re trying to set two different times for two different valves in A, that’s your problem there. The start time numbers are not zone numbers. If you set zone 1 for 10 minutes and zone 2 for 10 minutes, and set start time 1 for 10am and start time 2 for 6am, both zones will run consecutively at both of those times.

Why does my Pro-C controller not have a start time?

Choose from the links below for troubleshooting your PRO-C controller. Controller does not have a start time for each station. Cause – Too many start times (user error). Solution – Only one start time per active program is required. The Start Time numbers do not represent station numbers. For more information on this topic, view full article here.