Where is the pilot light on a AO Smith water heater?
Where is the pilot light on a AO Smith water heater?
Press down on the ignitor button while holding the red set button, until you see the pilot light come on. You may have to press the ignitor button a couple times until the pilot is lit.
Does AO Smith water heater have a reset button?
The reset button: a red button located on the water heater itself (just above the thermostat) that trips when the water temperature exceeds 180 F.
Do you have to light pilot light on old water heater?
Some old water heaters will need to be lit with a match. The only real caution is if you are smelling gas. If so, don’t light it! You need to let the gas clear out. If it’s a constant gas leak, call a service guy for help.
Can a 50 gallon water heater be used?
With this water heater tank being powered by natural gas, it can reliably provide your home with more than adequate hot water even if you have a large family. The bigger your family is, the more heating water needs, and this 50 gallon natural gas water heater is up to the challenge.
Which is the best gas water heater to buy?
The PROG50-38N Residential Gas Water Heater is another feather to add to the Rheem cap of effective heaters. This model is energy star approved so that you would be eligible for some rebates. It has a first-hour rating of 88 gallons and a recovery of 43.4 gallons.
Do you need to light your water heater with a match?
Click here → Some old water heaters will need to be lit with a match. The only real caution is if you are smelling gas. If so, don’t light it! You need to let the gas clear out. If it’s a constant gas leak, call a service guy for help. Loading…
Why does the pilot light go out on an A.O.Smith water heater?
Occasionally, the pilot light on your A.O. Smith water heater might go out due to an interruption of service or repairs needed on the appliance. A.O. Smith water heaters, including the Conservationist model, use a modern built-in piezoelectric igniter system that allows you to light the pilot by pushing the ignition button.
How do you light the pilot light on a water heater?
Turn the gas control knob on the side of the water heater to the “Off” position, and allow the room to air out for approximately 10 minutes. Set the gas control knob to the “Pilot” position. Push down on the red pilot set button to let the gas run to the burner assembly.
With this water heater tank being powered by natural gas, it can reliably provide your home with more than adequate hot water even if you have a large family. The bigger your family is, the more heating water needs, and this 50 gallon natural gas water heater is up to the challenge.
How do you turn on the pilot light?
Press down on the ignitor button while holding the red set button, until you see the pilot light come on. You may have to press the ignitor button a couple times until the pilot is lit.
