What kind of boiler is the Laars mascot?

Laars Mascot Boiler Overview The Laars Mascot is a discontinued high-efficiency, wall-mounted condensing combi boiler with up to 96% efficiency. It featured a stainless steel primary heat exchanger with externally welded manifolds, and a stainless steel brazed plate secondary heat exchanger for almost instantaneous direct hot water.

What should inlet gas pressure be on a Laars boiler?

A. Consult gas utility company. Inlet gas pressure to boiler should be 5.5” to 10.5″ water column on natural gas. 0.0″ to 13.0″ on propane gas. B. Pressure should be regulated within limits shown above. C. Replace thermocouple.

Why is my Laars endurance boiler not working?

The boiler control will not allow the Endurance to fire in this condition. This fault indicates that there is either something mis-wired on the boiler, or that the relay in this circuit has seized.

How to troubleshoot a Laars ebp0110 boiler?

Laars EBP0110 boilers troubleshooting Code Solutions F1 Boiler control internal error F3 Gas valve status is on, with no call for F4 Supply sensor error F5 Tank sensor error (EBP only)

Where can I order parts for my Laars?

However, Laars does not sell directly to consumers or contractors. Please contact your local Laars Sales Representative or your local Laars wholesaler to order parts for your Laars Product. Be sure to have your product model and serial number available when you call.

What is hold / alert fault code for Laars boiler?

Hold/Alert fault codes applicable for all Laars boiler models Reset module. In instances when the fault repeats, replace module Verify the module and display connections. Verify the module power supply and make sure that frequency, voltage and VA meet the specifications. Internal sub-system fault.

Who is the best service technician for a Laars boiler?

All Laars commercial and domestic use boilers should be installed and serviced by a professional service technician that is specialized in hot water boiler maintenance and installation and is Gas Safe Registered. Working on a gas appliance without proper qualification is prohibited by law and can cause various material damages.

Is the mascot boiler a wall mounted boiler?

The Mascot FT is a cascadable high-efficiency wall mounted boiler that easily satisfies the space heating needs of the modern home. Powering the Mascot FT is an advanced fire tube heat exchanger that uses the latest in heating tube technology to deliver quick heating response, exceptional efficiency, and years of reliable service.

How many units can a mascot ft heat?

The Mascot FT is cascadable up to 20 total units, for a maximum heating capacity of 4 million BTU/h. Enjoy the quick heating response, exceptional efficiency and years of reliable service that the Mascot FT delivers. Greatly reduce your home’s heating cost when compared to older, low efficiency boilers!

Who are Laars Heating systems and what do they do?

Learn About Who We Are. Laars Heating Systems is one of the nation’s leading boiler and water heater manufacturers for both residential and commercial heating. From high-efficiency, combination systems for residential heating and hot water to systems that supply entire stadiums, the Laars family of more than two dozen heating products…

Which is the most efficient Laars water heater?

The MagnaTherm, our premier condensing stainless commercial model, now has Laars Linc® control technology and 95% thermal efficiency. Over the years, the ultra high efficiency NeoTherm has proven itself as a dependable hydronic boiler or water heater. Available in 8 sizes from…

What kind of heat exchanger does a Laars water heater use?

The Laars Plate™ is a double-wall plate and frame water-to-water heater constructed with a 316 Stainless Steel heat exchanger. Fully… Laars-Stor Single Wall – Commercial – Indirect (tank-type), Carbon Steel & Stainless Steel.

What kind of boiler is the Laars mascot?