What is the code for Whirlpool whes33 softener?
What is the code for Whirlpool whes33 softener?
Use the following procedures to advance the water model code (“LE31” for Model WHES30 or “LE33” softener through the regeneration cycles to check for Model WHES33) shows in the display. This operation. code identifies the softener model.
What are the features of the Whirlpool whes33?
Customizing Features / Options (Models WHES30 & WHES33) CLEAN / CLEAR WATER IRON REDUCTION MAXIMUM DAYS BETWEEN REGENERA- TIONS This feature is beneficial on water supplies containing ferrous (clear water) iron. The default setting is OFF.
When to use Whirlpool whe WSC water softener cleanser?
The one year full warranty period on parts and labor can be extended to two years from the date of purchase if you use Whirlpool™ WHE-WSC Water Softener Cleanser on your system. Use one bottle of Whirlpool™ WHE-WSC Water Softener Cleanser, as directed, every four months from the date of purchase of the water softener.
How to install Whirlpool whes33 Venturi brine tank?
Page 9 Installation Instructions TURN OFF WATER SUPPLY Nozzle Top Cover Venturi Brine Tank 1. Close the main water supply valve, located near the Assembly Overflow well pump or water meter. Elbow Nut – 2. Open all faucets to drain all water from house pipes. Ferrule NOTE: Be sure not to drain water from the water Salt…
What are the features of the Whirlpool whes33 water softener?
Page 14 Customizing Features / Options (Model WHES20) SALT EFFICIENCY MAXIMUM DAYS BETWEEN REGENERA- TIONS When this feature is ON, the water softener will oper- ate at salt efficiencies of 4000 grains of hardness per The water softener automatically controls regenera- pound of salt or higher (May recharge more often tion frequency.
How to check Whirlpool whes33 water model code?
Verify for all settings (time, hardness, etc.): brine draw from the brine tank by shining a flash- light into the brinewell and observing a noticeable… Use the following procedures to advance the water model code (“LE31” for Model WHES30 or “LE33” softener through the regeneration cycles to check for Model WHES33) shows in the display.
Page 9 Installation Instructions TURN OFF WATER SUPPLY Nozzle Top Cover Venturi Brine Tank 1. Close the main water supply valve, located near the Assembly Overflow well pump or water meter. Elbow Nut – 2. Open all faucets to drain all water from house pipes. Ferrule NOTE: Be sure not to drain water from the water Salt…
What’s the default setting for the whirlpool water softener?
The default setting is OFF. The water softener automatically controls regenera- When this feature is set to ON, an additional back- tion frequency. Routine Maintenance ADDING SALT CLEANING THE NOZZLE & VENTURI Lift the salt lid and check the salt storage level fre- A clean nozzle & venturi (See Figure 43) is a necessity quently.
