What happens when you flush a toilet with Flushmate?
What happens when you flush a toilet with Flushmate?
When the toilet is flushed, this energy pushes the water into a specially designed toilet bowl. A toilet equipped with FLUSHMATE must be specifically designed to accommodate the effectiveness of FLUSHMATE. FLUSHMATE is NOT a retrofit product.
How to troubleshoot a Sloan toilet flush handle?
For flush-handle fixtures, observe the clearance. (See Figure 1) If necessary, adjust the Actuator to allow for proper clearance. When proper clearance is obtained, tighten the setscrew. Turn off the water supply valve. Flush the toilet to relieve the pressure. Disconnect the water supply line from the Supply Shank (A). (See Figure 6)
How can I change the handle on my toilet?
Steps Look at the bigger picture. Examine your flush handle. Examine the flush lever nut. Shut off the water supply. Drain the water. Examine the flapper chain. Examine the trip lever. Examine the flapper. Buy and install replacement parts. Turn the water supply on. Wash your hands.
What should I do if my toilet won’t flush?
Check water pressure, marginal pressure can cause any of these conditions. If sufficient water pressure has been verified and the toilet continues to run-on, the following steps may be required: Make sure the water supply valve is fully open. Check the Actuator adjustment.
For flush-handle fixtures, observe the clearance. (See Figure 1) If necessary, adjust the Actuator to allow for proper clearance. When proper clearance is obtained, tighten the setscrew. Turn off the water supply valve. Flush the toilet to relieve the pressure. Disconnect the water supply line from the Supply Shank (A). (See Figure 6)
What to do when your Flushmate won’t flush?
Reconnect the water supply line and fully open water supply valve. Check Air Inducer for sufficient air draw. Place a small amount of water (two to three drops) over the hole on top of the Air Inducer Cap (See Figure 14) and flush the toilet. If the Air Inducer is working properly, the water will be drawn in. (See Figure 15)
How does a Flushmate pressure assisted toilet work?
The FLUSHMATE® Pressure-Assisted system is a component inside of a specially designed toilet that harnesses the pressure from the water supply line to provide the energy needed to complete the flush. The FLUSHMATE® Pressure-Assisted technology cannot be retrofitted into a standard,…
Why is my Flushmate 503 not working properly?
Reinstall Flush Rod and handle linkage. Inadequate water pressure, an improperly adjusted Flush Valve Cartridge, a clogged inlet screen, or insufficient air draw may cause a weak, sluggish, or no flush condition. Make sure that the water supply valve is fully open.
