What are normal toilet dimensions?

What are normal toilet dimensions?

Standard toilet dimensions are typically between 28–30″ deep, roughly 20″ wide, between 27–32″ high, and have a rough-in between 10–14″.

How is toilet Length measured?

Measure from the wall behind the toilet to the center of one of the closet bolts (which hold the toilet down). If the toilet has four closet bolts, measure to the center of one of the rear ones. Then measure from the center of the mounting holes to the back of the new toilet you’re considering.

What does 12 inch rough-in mean for toilets?

The toilet rough-in refers to the distance from the finished wall to the center of the toilet’s floor drain or waste outlet. Most toilets have a rough-in of 12 inches, although it’s not uncommon for older homes to have an unusual size such as 10″ or 14″.

What is the standard size of a toilet?

What is the standard size of a toilet? The general rule of thumb for standard toilet sizing is between 27 and 30 inches deep, the back height is usually between 21 to 31 inches and the width is about 20 inches. It is also important to note that an ada compliant toilet must be of 17 to 19 inches in seat height.

What’s the best way to measure for a toilet?

If measuring for a replacement toilet, just measure from the back wall to the center of the toilet drain and write down the measurement. Usually, the distance is 12 inches, so a standard toilet will fit just fine in this space. Oversize toilets may not fit in this area however.

How tall is a 2 piece toilet seat?

In addition to being long, the Back-to-Wall Elongated 2-Piece Toilet also has some notable height advantages. The seat itself is 16.5 inches above the finished floor. This height allows most average to tall-sized adults to sit very comfortably atop the throne.

What should be the distance between the toilet and the wall?

#1. The Distance To Set The Toilet Flange From The Back Wall. You’ll want to set the center of the water closet flange 12 inches from the finished back wall. Don’t measure from the base molding! Take this measurement from the finished wall. Now, if you’re measuring from stud walls, add in the thickness of your wall.