How to light the pilot light on Richmond water heaters?
How to light the pilot light on Richmond water heaters?
Bleed the lines according to the instructions provided with your model Richmond water heater and try to light the pilot light again. If your water heater does not light after 4 trys, or if on a gas water heater, you smell gas when the feed line is turned off, do not attempt to light the pilot. Call a water heater technician immediately.
When does the status light on my water heater stop blinking?
If the status light turns solid red, release the gas The status light will stop blinking and stay on for a short time after the water heater is turned off. See Figure ‘A’.
How does a Richmond VA water heater work?
Offers simple and easy to read diagnostics and leak protection with audible alarm. Circulates hot water from the heater through the home’s plumbing allowing hot water to be ready at the tap when needed. Offers continuous hot water quick and on demand for single point-of-use or multiple applications.
What should I do if my water heater is not flashing?
To reduce the risk of property damage, serious injury or death, read and follow all labels on the water heater and the safety instructions in the printed owner’s manual. Look at the Status Light on the gas control valve. If the Status Light is flashing more than once every three seconds or not flashing at all, select the appropriate code below.
What should I do if my water heater status light is not flashing?
Look at the Status Light on the gas control valve. If the Status Light is flashing more than once every three seconds or not flashing at all, select the appropriate code below. If the Status Light is flashing once every three seconds, the pilot light is lit and the gas control valve is working properly.
Offers simple and easy to read diagnostics and leak protection with audible alarm. Circulates hot water from the heater through the home’s plumbing allowing hot water to be ready at the tap when needed. Offers continuous hot water quick and on demand for single point-of-use or multiple applications.
What to do when your status light does not blink?
If the status light does not start blinking after 90 seconds, release the gas control knob, turn the gas valve off, and wait 10 minutes before attempting to relight the pilot. On newly installed water heaters, it may take up to 2-3 lighting attempts before the pilot lights and the status light starts blinking.
How can I get my York PA water heater to stop blinking?
If you can’t get your water heater in York, PA light to stop blinking, or if you’ve noticed any of the warning signs we’ve outlined here, contact us at Air Comfort Technologies. We’re available 24 hours a day to answer your call. Depending on the problem, reaching out right away could be the difference between a quick repair or a big disaster.
