How does a Paloma water heater work?

How does a Paloma water heater work?

When a hot water faucet is opened, gas will pass through many orifices to a stainless steel burner that mixes gas with air and distributes the flame over the copper heat exchanger. When the faucet is closed, the tankless water heater goes into standby mode and does not operate until hot water is demanded again.

How to reset my Rheem tankless water heater?

Here how to do it right:

1. Begin with turning the hot water tap off.
2. Take the remote control and turn it off as well.
3. Now it’s time to wait. 5 minutes or so should be enough in most cases.
4. Continue with turning the tankless water heater back on.
5. Open the hot water faucet and see what’s happening.

Who bought Paloma?

Paloma III amassed a 23,700-net-acre dry-gas Utica position, which was ultimately purchased by Gulfport Energy (NASDAQ:GPOR) in August 2015 for $301 million.

Where is the reset button on my Rheem tankless water heater?

Where is the reset button on a Rheem water heater?

1. Turn the water heater’s gas valve switch to the “OFF” position, wait for a few seconds and then flip the switch to the “ON” position to reset the system.
2. The water heater reset button is the red button located on the water heater itself (just above the thermostat).

What’s the serial number on a Paloma water heater?

Specify model and serial number when placing order. PH12,16,24 water heater is working but a small amount of water is leaking from 1/8″ diameter hole directly above top of water control case assembly (part #110). Purchase water valve rebuild kit and replace O-ring part #108.

How to troubleshoot a Paloma tankless water heater?

Turn the hot water faucet on and open it to full capacity. The tankless unit should start up again when you turn on the hot water faucet. Refer to your instruction manual if the error code is still displayed. Refer to your manual if the error code remains displayed.

What makes a Paloma water heater turn yellow?

1. Observe pilot light with front cover removed. Any yellow indicates a plugged pilot air filter. A yellow flame is weak, tentative, lazily drifting, without continuous bearing on thermocouple tip. Solution: Take a deep breath and blow out the obstructed pilot air filter or use compressed air.

What causes pilot flame outage on Paloma water heater?

Twenty-five seconds is normal. Three components are responsible for pilot flame outages: thermocouple (usually lasts 10+ years), magnetic valve (only a problem after it’s disturbed; do not disturb it), or fuse circuit fusible link (usually the part that we replace). Through the process of elimination we will determine which part is at fault.