How do you reset an automatic pilot light?

How do you reset an automatic pilot light?

You won’t need any tools to reset the pilot.

1. Set the thermostat on your furnace to its lowest setting.
2. Remove the access panel covering the gas control knob.
3. Turn the gas control knob to the OFF position.
4. Turn the gas control knob or knobs to the ON position.
5. Turn the electrical power to the furnace back on.

Why does my pilot light keep going out?

If your pilot doesn’t re-light, won’t stay lit or keeps going out after a short time, you most likely have an issue with the hot water heater thermocouple. This can happen with age. This can happen with age.

What to do if your hot water heater pilot light won’t stay lit?

If you have followed these steps and your water heater pilot light won’t stay lit, you may need professional help to fix the problem, give All Masters a call if you live in Arlington TX, and we can fix any of your hot water heater thermocouple or pilot light issues!

What to do if your furnace pilot light is not working?

First be sure that the thermocoupler hasn’t slipped or shifted and not getting the full flame from the pilot light. If that’s not the problem, then replace the thermocoupler and check that the pilot light is clear of any debri.

Can a pilot light be replaced without a thermocoupler?

Since thermocouplers are so inexpensive, replacing it and cleaning the pilot light should always go hand in hand. Never do one without doing the other. 4) Transformer.A transformer converts the 110 volt power coming into your furnace to 24 volts for use by certain parts including the thermostat.

Why does your pilot light not light all the time?

Common Reasons Your Furnace Pilot Won’t Light. There are several possible reasons why your gas furnace pilot won’t light: an ongoing draft, a faulty thermocouple, an accumulation of dirt, or an inefficient supply. Ongoing Draft. Over the years, your pilot light may blow out periodically due to a strong draft during storm activity, or during times when there is a high wind.

Why isn’t the pilot light staying lit?

The flex tube is how the gas reaches the device, and if the continuous flow of gas is interrupted, the pilot light won’t stay lit. This usually happens when the tube is kinked at one or many points. Check the flex tube: Check along the tube to straighten it, so there’s no obstruction to the flow of gas.

Why is my furnace pilot not staying lit?

The most common reason the furnace pilot light won’t stay lit. Bad Thermocouple. A furnace thermocouple is a safety feature that regulates gas flow to your system based on whether the pilot light is on. In simple terms, the thermocouple checks to see if your pilot light flame is lit and turns off the gas flow if it senses that your pilot light is off, so you don’t have gas building up in your home.

What to do if your pilot light goes out?

If the pilot light goes out, you can relight it after the gas is shut off using a match or the unit’s electronic ignitor if it has one, following the proper safety precautions. If your gas is shut off, turn the gas shutoff valves on all gas appliances to the “off” position until the gas service is restored.