How do you drill a hole in a Franke Kitchen Sink?
How do you drill a hole in a Franke Kitchen Sink?
If there is NO coloured dot on the front face of the sink, use the hole drill bit provided (FUN 112.0473.656) which is stuck to the back of the drainer next to the sink bowl. Drill out the taphole FROM THE BACK OF THE SINK. For further information please see the instruction sheet enclosed with the sink, which can be viewed here.
What kind of sink do you get from Franke?
Choosing which material is right for your kitchen depends on what you need from your sink. Each precision-engineered material has an individual character and unique benefits. Franke Granite undermount sinks, for instance, are available in six nature-inspired tones and deliver gorgeous aesthetics.
How is a bond made on a Franke Kitchen Sink?
Despite any regulatory enforcement, in common with many sink manufacturers Franke make provision for a mechanical bond to be made to inset sink models. This is often done by utilising one of the cut-out points for the clips along the length of the clip rail.
How to find out what cut out dimensions are necessary for my Franke Kitchen system?
How do I find out what cut-out dimensions are necessary for my Franke stainless steel sink? As a general guide, cut inside the overall frame dimension (by inverting the sink on the worktop) by 8mm all round and always use a 20mm (important!) radius at the corners. Cut out sizes are shown on the specification sheet for each sink.
Where can I buy Franke Little Butler hot water dispensers?
New York Replacement Parts is proud to be a distributor of Franke bathroom, kitchen and shower faucet repair parts as well as Franke Little Butler hot water dispensers and repair parts for over 25 years. We have an extremely dedicated and knowledgeable staff that will help you find all the Franke parts you need. Help? Franke Help? Need some help?
If there is NO coloured dot on the front face of the sink, use the hole drill bit provided (FUN 112.0473.656) which is stuck to the back of the drainer next to the sink bowl. Drill out the taphole FROM THE BACK OF THE SINK. For further information please see the instruction sheet enclosed with the sink, which can be viewed here.
What are the parts for a Franke kitchen faucet?
We have all the parts to repair just about every Franke faucet made from newer models to older ones. Here you can find a huge selection od Faucet Handles, Cartridges & Stems, Aerators, Spray Hoses, Side Sprays, Spray Heads and more to keep your Franke Kitchen Faucet running smooth and looking new all year round.
How big of a tap hole do you need for a Franke tap?
Most Franke taps require the industry standard taphole cut out size of 35mm diameter. There are several exceptions to this as follows: Bridge & Bridge Lever – tap requires 2 x 25mm diameter tapholes
