How do you adjust the scald on a shower faucet?

Grab the scald guard with your fingertips and pull it from the handle assembly. Rotate the guard counterclockwise to increase the water temperature and counterclockwise to decrease it. Each notch on the guard represents a water temperature difference of 4 to 6 degrees.

Do shower valves have anti-scald?

An anti-scald pressure balancing valve is a special device that’s built into the shower handle that regulates the water pressure from the hot and cold water lines to prevent sudden, extreme changes in temperature. If your shower doesn’t have one, your water temperature may get so hot it can cause burns.

How do you remove a scald device from a faucet?

Pry the cap off handle’s center exposing the screw underneath. Take out the center screw with a screwdriver or use an Allen wrench loosening a hollow-set screw in the side. Pull the round, metal plate on the valve assembly’s end toward you in the open, locked position.

How do you adjust a scald valve?

Slide the shower handle off the stem to expose the “Rotational Limit Stop” anti-scald valve. Grab the center of the “Rotational Limit Stop” and pull it toward you. Turn the Delta anti-scald valve to the left to increase the maximum temperature of the water, or turn it to the right to decrease the water temperature.

What is the anti-scald device?

Anti-scald valves, also known as tempering valves and mixing valves, mix cold water in with outgoing hot water so that the hot water that leaves a fixture is not hot enough to scald a person.

Can I remove anti scald valve?

Why is there a scald valve on a Kohler shower?

Kohler shower faucets have an anti-scald valve that prevents the water from reaching temperatures that will burn skin. This helps prevent accidentally turning the hot water on too high at any time. This is beneficial especially for families with small children. Sometimes it is necessary to adjust the scald valve on a Kohler shower.

How do you change the handle on a Kohler shower?

Making adjustments depends upon how much of a temperature change is necessary. Remove the screw securing the shower handle to the faucet stem with a Phillips-head screwdriver or hex wrench depending upon the set screw head. The set screw is under the curve of Kohler lever handles. Pull the handle away from the faucet stem.

How to identify single control Bath and shower valve?

This allows you to expose the valve for proper identification. For assistance with removing the trim, refer to “Identify and Remove Single-Control Bath and Shower Trim”. Once the trim is removed, refer to the information below to identify your shower valve.

Where is the temperature regulator on a Kohler shower?

Locate the valve stem and collar on the temperature regulator. These are pieces that would connect to and turn the handle if it were still attached. You’ll then need to turn the valve stem and collar clockwise; this should initiate the hot water’s flow. Be careful of splashing yourself since the water may be too hot.

Where are the set screws on a Kohler shower?

The set screw is under the curve of Kohler lever handles. Pull the handle away from the faucet stem. Locate the screws securing the faceplate to the shower wall. Depending upon your model, the screws either are clearly visible on the front of the plate or hidden along the outside edges of the plate.

How do you adjust the scald on a shower faucet?