How do I reset my Rinnai water heater after a power outage?
How do I reset my Rinnai water heater after a power outage?
You simply press and hold the Connect button on your module, until you see the LED blinking White. Release it afterward. The procedure will restore the module to the factory setting of your unit.
How do I turn on my water heater after a power outage?
Tripped Circuit Breaker – Due to a surge in electricity, when the power came back on, the circuit breaker may have tripped. To rectify, you will have to push the tripped circuit breaker back to “On” position. Once that is done, your water heater should start functioning normally.
Will a tankless water heater work during a power outage?
While on-demand gas water heaters don’t rely on electricity as a fuel source to heat water, on-demand heaters usually have a control panel that is powered by electricity which is the ‘brains’ of the water heater. So even a tankless gas water heater will not work independently in a power outage.
What to do if your Rinnai heat exchanger keeps beeping?
How to Fix: Flush the heat exchanger as per the recommended flushing procedure found in the owner’s manual. To temporarily reset the code, press the ON/OFF button 5 times. This will allow the unit to operate for 70 hours after which another LC code will lock the unit from operating.
Why is my Rinnai tankless water heater beeping?
Press the “Priority button” on the temperature controller. The green Priority light will glow indicating that this controller is controlling the temperature and that the Rinnai Tankless Water Heater is ready to supply hot water. IMPORTAnT: The priority can only be changed while no hot water is running.
How to check power supply on Rinnai hairdryer?
Checkpower supply (Plug another appliance (ie hairdryer) into power point and test. If a controller is fitted check that it is on also) Check gas supply (Turn gas stove top on then turn hot water tap on.
What should I do if my Rinnai controller is not working?
If a controller is fitted check that it is on also) Check gas supply (Turn gas stove top on then turn hot water tap on. If flame drops on stove this shows it is possibly a gas supply issue) Is there enough water flowing? (Try opening tap further or turn another tap on as well) Are there any error codes displayed on controllers?
How to Fix: Flush the heat exchanger as per the recommended flushing procedure found in the owner’s manual. To temporarily reset the code, press the ON/OFF button 5 times. This will allow the unit to operate for 70 hours after which another LC code will lock the unit from operating.
Press the “Priority button” on the temperature controller. The green Priority light will glow indicating that this controller is controlling the temperature and that the Rinnai Tankless Water Heater is ready to supply hot water. IMPORTAnT: The priority can only be changed while no hot water is running.
Checkpower supply (Plug another appliance (ie hairdryer) into power point and test. If a controller is fitted check that it is on also) Check gas supply (Turn gas stove top on then turn hot water tap on.
If a controller is fitted check that it is on also) Check gas supply (Turn gas stove top on then turn hot water tap on. If flame drops on stove this shows it is possibly a gas supply issue) Is there enough water flowing? (Try opening tap further or turn another tap on as well) Are there any error codes displayed on controllers?
