How do I fix a dry hot tub error?
How do I fix a dry hot tub error?
This error message is similar to the FLO error message. Like FLO issues, this can commonly be fixed by topping off your hot tub water level. DR or DRY will show up if there is little to no water travelling through your heater.
How do you clear error codes on a hot tub?
Open the spa cover and let the spa cool down for 10 minutes, then touch the control panel to reset the circuits, or push a red reset button on air systems. For OH, HH or HOT trouble codes, an overheating hot tub is not usually a heater problem. It is almost always a flow problem.
Will a hot tub motor run without water?
This means no water flow no heat. The only damage you could have had would be if the pump was on with no water. A hot tub is not like a water heater. It is only heating flowing water and not standing water.
Why does my hot tub Say DR or dry?
DR or DRY will show up if there is little to no water travelling through your heater. There are a few simple things you can do to fix this problem. However, turn off the GFI and manually disconnect the power to the pump and heater before troubleshooting.
What does it mean when your spa water is too hot?
M030-The heater is too hot. Means one of the temp sensors for the water has detected a temp of 118°F (47.8°C) inside the heater. The system also shuts the spa down. Once water temp is below 108°F (42.2°C), you must clear the message.
What does it mean when your spa heater starts again?
Indicates possibility of inadequate water flow to heater to carry heat away from the spa unit’s heating element. Check to determine conditions such as closed valves, suction flow restrictions, pump prime, low water level, trapped air and too many closed jets. Heater starts again after 1 min.
What to do if your hot tub heater is dry?
First, check the water level in the tub. If the water is low, add water to the proper level and try restarting the pump and heater. Check for other problems that can impair or block water flow through the heater.
What causes a hot tub heater to be dry?
A dry hot tub heater problem can have several different causes. The electric water heater in your hot tub ensures your water will have a comfortable temperature whenever you want to use the tub. Most hot tubs pump their water through a heater tube that contains an electric heating element to warm the water as it recirculates.
M030-The heater is too hot. Means one of the temp sensors for the water has detected a temp of 118°F (47.8°C) inside the heater. The system also shuts the spa down. Once water temp is below 108°F (42.2°C), you must clear the message.
Indicates possibility of inadequate water flow to heater to carry heat away from the spa unit’s heating element. Check to determine conditions such as closed valves, suction flow restrictions, pump prime, low water level, trapped air and too many closed jets. Heater starts again after 1 min.
What to do if your hot tub says Dr or dry?
Like FLO issues, this can commonly be fixed by topping off your hot tub water level. DR or DRY will show up if there is little to no water travelling through your heater. There are a few simple things you can do to fix this problem.
