Do modern kitchen taps have washers?
Do modern kitchen taps have washers?
Some modern mixer taps (including monobloc taps) operate with ceramic discs instead of rubber washers, which are hidden inside cartridges within the tap. There is one cartridge for hot water and another for cold water.
How to replace washer, valve seat, and stem?
1 – put in new valve seats and flat washers on the hot, cold, and diverter (the washer on the diverter was completely dissolved… I’m surprised it was working at all). 2 – put in new valves/stems on the hot and cold, with a little extra graphite packing as suggested, to keep the stems from being too tight.
How do you change the seat on a washer?
Changing the valve seat is simple if you have a seat wrench and a seat sleeve in your toolbox. Turn the wrench counterclockwise to loosen the valve seat and pull it out. Check for scratches and marks of friction from the washer, or for buildup from your water.
Why does my washer valve seat and stem keep leaking?
Be sure the stems are in the open position before inserting them into the body of the faucet. The washers can bind against the seats during tightening causing damage. And sometimes you can do everything right and it still leaks. No obvious reason why it just does. Service plumbing makes me pull my hair out.
What to do if your faucet is still leaking after replacing the stem?
After using the Valve Seat Grinder, rinse off the valve seat and reattach to the faucet. If your faucet is still dripping, you will need to replace the faucet valve seat. Buy an identical valve seat from the plumbing or home supply store. Install this and check for leaks.
1 – put in new valve seats and flat washers on the hot, cold, and diverter (the washer on the diverter was completely dissolved… I’m surprised it was working at all). 2 – put in new valves/stems on the hot and cold, with a little extra graphite packing as suggested, to keep the stems from being too tight.
Can a beveled washer valve seat be replaced?
Beveled washers arn’t needed much anymore. Well replacing the hot water valve seat was a great suggestion, and once I got it out and saw just how damaged it was, I thought for sure that that was the main problem… however, (sigh), it is still dripping after following all the suggestions!!! (about 2in. of water in a 2 gal. bucket overnight.)
After using the Valve Seat Grinder, rinse off the valve seat and reattach to the faucet. If your faucet is still dripping, you will need to replace the faucet valve seat. Buy an identical valve seat from the plumbing or home supply store. Install this and check for leaks.
Changing the valve seat is simple if you have a seat wrench and a seat sleeve in your toolbox. Turn the wrench counterclockwise to loosen the valve seat and pull it out. Check for scratches and marks of friction from the washer, or for buildup from your water.
