Are triangle tube boilers good?
Are triangle tube boilers good?
Triangle Tube earns a Poor rating for predicted reliability, the lowest score, and a Very Good rating for owner satisfaction, which reflects how likely a member is to recommend that brand. We test thousands of products so you can create your best home.
Who makes triangle Tube boilers?
Groupe Atlantic
Triangle Tube is owned and operated by Groupe Atlantic, owners of Ideal Boilers. Ideal manufactures over 450,000 boilers a year, including Triangle Tube products.
Where are triangle tube boilers made?
Triangle Tube is headquartered in West Deptford, NJ with a manufacturing facility and a state-of-the-art training center. Triangle Tube is owned and operated by Groupe Atlantic, owners of Ideal Boilers. Ideal manufactures over 450,000 boilers a year, including Triangle Tube products.
Why do I need a triangle tube in my water heater?
1) This often is caused by the dry contact in the aqua-stat in the domestic water heater. The dry contact water heater’s aqua-stat should be replaced with a PSRKIT-22 Triangle Tube IDHS. This will now allow the boiler to see the actual temperature in the tank and determining when to go into water heating operation.
What do you need to know about triangle tube heat exchanger?
Ensure the boiler and heating system have been properly purged and there is no air trapped in the top of the heat exchanger. Inspect and verify heating system piping and its components.
Can a psrkit-22 triangle tube be used in a contact water heater?
The dry contact water heater’s aqua-stat should be replaced with a PSRKIT-22 Triangle Tube IDHS. This will now allow the boiler to see the actual temperature in the tank and determining when to go into water heating operation.
What should the O2 reading be on a triangle boiler?
If the O2 reading is above 3.9% turn throttle screw CCW to lower the O2, if the reading is below 3.9% turn the throttle CW to increase the O2. Set the boiler into LOW fire. Hold in the “Mode” and the “-” buttons simultaneously until the first digit flashes “L”. Check the O2 reading in low fire, it should not differ more then 2/10 of a percent.
